3 in 1 SSD Enclosure
M.2 NVME to USB-C: support M.2 NVME SSD (Key-M) as bellow:
- Samsung 950Pro/ 960Evo/ PM951/ PM961/ SM951/ SM961/970 EVO /970 PRO and other M.2 SSDs with PCI-E (M-KEY) Interface Type.
- Support Intel Optane SSD 800P SeriesS
- Support Intel SSD 760p SeriesS
- Support Intel SSD 660p SeriesS
- Support Intel SSD 600p Series
M.2 SATA to USB-C: support M.2 SATA SSD (Key B/B+M) as bellow:
- Samsung 860 EVO/850 EVO/Crucial MX500/Crucial MX300/WD Blue 3D NAND, etc.
2.5 inch SATA SSD to USB-C: support 7mm/9.5mm thickness 2.5 inch SATA SSD
3 Separate PCB Board Design
- Long-term use of electronic equipment will inevitably lead to failure. In our product, there are 3 kinds of separate PCB board, any one failure will not affect the other two.
- To save your cost, you only need to replace the faulty PCB board, and keep other two PCB board.
- This product not only supports 3 kinds of SSDs, but also provides a low-cost spare parts replacement solution.
- This is the most cost-effective and practical SSD enclosure solution, and maybe it will accompany you forever.
|
|
|
|
USB Cable
- USB-C to C cable;
- USB-C to A cable.
|
M.2 SSD Installation
- Secure M.2 NVME SSD with screw;
- Secure M.2 SATA SSD with screw.
Note: Do not include M.2 SSD.
|
2.5 inch SSD Instalation
- Anti-vibration kits are included, especial for 7mm thickness SSD;
- Install as picture shown.
Note: Do not include 2.5 inch SSD.
|
Thermal Silica Installation
- Remove the protective film of 10 small square silica gel pad
- Put the small square silica gel pad on the surface of SSD chip/flash
|